While applying healing crystals, one occasionally discovers that they either become ineffective, their effect changes, or they actually feel downright unpleasant. The reason for this is that crystals not only transmit energetic information, but also absorb it. In particular, in the case of intense healing processes “disease information” can be absorbed. This, after some time, may then overshadow the crystal’s inherent “healing information”.
Therefore, prior to beginning, the crystals being applied should be “cleansed” of electrical charges after use. In particular, with direct body contact, many crystals absorb an electrostatic charge. The most extreme case occurs with the use of Amber, which can become quite hot after a couple of minutes application. The best method of discharging the static charge is to hold the crystal under running water for 10-20 seconds.
The absorbed information, however, still remains stored in the crystal after the discharge. Without further cleansing, the information will still be active during the next treatment. In order to delete this information, the crystal can be placed either inside an Amethyst druse or on a piece of an Amethyst druse. Amethyst has a strong, fiery radiation caused by its finely distributed iron atoms and energy concentration; crystals that are energized in this way are freed of the absorbed information. As a rule, this process takes about a day. If the crystal has only been applied for at short time, an hour will be sufficient; however, it will not be harmed if you allow it to remain in the Amethyst druse for a longer time.
As the intensity of a crystal’s effectiveness is connected with the absorbed energy, the cleansed crystals can be recharged in one’s hand or in sunlight (morning or evening). The absorbed heat energy intensifies the crystal’s effect. In many cases, however, such recharging is unnecessary as the crystal has already been warmed up and stimulated by body contact.
Crystal Healing News